upgarde

[hatcher1981]

I am trying to run the scalix installer. I get all the way to the screen were i select which components to upgrade. At this point i can no longer click the forward button. It is as though the button is disabled. Same thing if i rn from the command line also.

[rootkit]

use the cli

./scalix-installer --cli

[les]

I am trying to run the scalix installer. I get all the way to the screen were i select which components to upgrade. At this point i can no longer click the forward button. It is as though the button is disabled. Same thing if i rn from the command line also.

Is this 11.3?

I just found with 11.3 last night the when upgrading (i always use the --cli anyway), it automatically figured out that 3,4,5,6,7,8,9,10,11,12 needed to be upgraded. 1 and 2 were not listed, but shown to be required. The installer would not let me hit enter, i had to type in 1,2,3,4,5,6,7,8,9,10,11,12 to continue.

Other than that everything went through fine.

[hatcher1981]

I am using both the gui and the --cli. On the --cli after i select which packages to upgrade and hit enter, it goes back to asking me to select which packages to upgrade.

[les]

I am using both the gui and the --cli. On the --cli after i select which packages to upgrade and hit enter, it goes back to asking me to select which packages to upgrade.

did you actually type in 1,2,3,4,5,6,7,8,9,10,11,12 ??

if so please copy and paste the output of the installer from cli mode so we can see whats going on.

[a.schild]

I am trying to run the scalix installer. I get all the way to the screen were i select which components to upgrade. At this point i can no longer click the forward button. It is as though the button is disabled. Same thing if i rn from the command line also.

Is this 11.3?

I just found with 11.3 last night the when upgrading (i always use the --cli anyway), it automatically figured out that 3,4,5,6,7,8,9,10,11,12 needed to be upgraded. 1 and 2 were not listed, but shown to be required. The installer would not let me hit enter, i had to type in 1,2,3,4,5,6,7,8,9,10,11,12 to continue.

Other than that everything went through fine.

Same here. (On CentOS 5)
I had to type in the 1,2,3,4,5,6,7,8,9,10,11,12 otherwise it just looped on the proposed 3,4,5,6,7,8,9,10,11,12

André

[hatcher1981]

I am using both the gui and the --cli. On the --cli after i select which packages to upgrade and hit enter, it goes back to asking me to select which packages to upgrade.

did you actually type in 1,2,3,4,5,6,7,8,9,10,11,12 ??

if so please copy and paste the output of the installer from cli mode so we can see whats going on.

That was it, sorry i feel dumb. Thanks for the help!