Scalix Forums

Hi Forum,

I installed Scalix Community Edition 11.2.0.52 as an RPM package on a VM with Fedora Linux FC7. The only "Error"-Statement in the Scalix install log concers the missing license.

When I enter "http://myscalix.de:8080/sac" into my Firefox, I get a "not found" error. The same happens with "http://myscalix.de:8080/". "http://myscalix.de/" shows a Fedora/ Apache-Standard page.

How can I get the Scalix configuration to run?

Thank you in advance for your support.

What does http://myscalix.de/sac or http://myscalix.de/webmail show you ?

What does http://myscalix.de/sac or http://myscalix.de/webmail show you ?

These URIs work! How embarassing for me, that I didn't try that before ...

Any concerns about the fact, that port 8080 doesn't work?

Why should it listen on port 8080 ?

a.schild wrote:Why should it listen on port 8080 ?

Because it was described like this in the installation documentation ...

Which documentation? because I cannot find anything about using port 8080 in my documentation?

Kris wrote:Which documentation? because I cannot find anything about using port 8080 in my documentation?

http://portal.knowledgebase.net/display/1n/kb/article.asp?aid=140316, Page 25f.

Hm, link doesn't work here..

But I think you can better use the documentation found here:

http://www.scalix.com/community/downloads/documentation.php

Good luck :)

Kris wrote:But I think you can better use the documentation found here:
http://www.scalix.com/community/downloads/documentation.php
Good luck

Thank you