Prepping for FC4 install
Moderators: ScalixSupport, admin
-
meganet
- Posts: 32
- Joined: Mon Nov 21, 2005 12:50 pm
Prepping for FC4 install
What is the bare minimum install I should do for FC4? Can I do just a base install and then install the dep's from there? Or have most you done complete installs minus any GUI/productivity stuff?
-
ScalixSupport
- Scalix
- Posts: 5503
- Joined: Thu Mar 25, 2004 8:15 pm
Hi Meganet,
Have a look at pages 8-13 of the installation guide. You will find a thorought discussion of installation requirements. In fact read on from there as the guide discusses system partitions, LVM, etc. I'd advise installing the GUI as the Scalix installation is GUI based. Once you've installed and are in production then go ahead and operate in runlevel 3.
Best wishes,
Don
Have a look at pages 8-13 of the installation guide. You will find a thorought discussion of installation requirements. In fact read on from there as the guide discusses system partitions, LVM, etc. I'd advise installing the GUI as the Scalix installation is GUI based. Once you've installed and are in production then go ahead and operate in runlevel 3.
Best wishes,
Don
Who is online
Users browsing this forum: No registered users and 6 guests