Admin Plugin - addpf.sh - subject with spaces problem
Posted: Thu Oct 04, 2007 10:09 pm
Hope this is the right place for this.....
I just installed the addpf.sh Administrator Plugin into an 11.1.0 server.
It installed fine.
I then added a new public folder via SAC as follows....
Name of Folder: SNTL0702 Frieda River
Common Name: Frieda River
Email Address: frieda_river@<domainprotected>
Mailnode: mail
The command it showed....
addpf.sh -s "SNTL0702 Frieda River" -c "Frieda River" -e frieda_river@<domainprotected> -n lates
It said it worked fine.
I tried to send an email and it got rejected saying the bulletin board didn't exist.
I then found that the public folder was created as "SNTL0702" not "SNTL0702 Frieda River"
After i renamed it it worked fine.
Thus there must be some little bug with the quoting of subjects with spaces in them.....
Anyone got any ideas?
I just installed the addpf.sh Administrator Plugin into an 11.1.0 server.
It installed fine.
I then added a new public folder via SAC as follows....
Name of Folder: SNTL0702 Frieda River
Common Name: Frieda River
Email Address: frieda_river@<domainprotected>
Mailnode: mail
The command it showed....
addpf.sh -s "SNTL0702 Frieda River" -c "Frieda River" -e frieda_river@<domainprotected> -n lates
It said it worked fine.
I tried to send an email and it got rejected saying the bulletin board didn't exist.
I then found that the public folder was created as "SNTL0702" not "SNTL0702 Frieda River"
After i renamed it it worked fine.
Thus there must be some little bug with the quoting of subjects with spaces in them.....
Anyone got any ideas?