Page 1 of 1

Problem with relay after spamassassin installation

Posted: Wed Nov 23, 2005 12:15 pm
by skf
i installed spamassassin on a scalix server and i got a problem - nobody can connect to scalix till i put the ip address or network in to the /etc/mail/access
And the second question do i need to make some settings for the spamassassin after installation becouse i think it doesn't work, How can i start logs for spamassassin

Thanks

Posted: Sat Nov 26, 2005 6:34 pm
by ScalixSupport
Hi. It sounds like you've setup SA using the two IP address method wth sendmail listening on one IP address and Scalix smtpd listening on the other. I assume when you say "nobody can connect to scalix" you mean none of your user's that submit messages with SMTP can connect. If that's the case, it's because you have the user's connecting to sendmail rather than Scalix. Have them go to ther other IP address (the one with smtpd listening) and they should be fine.

Thanks,
Rachel

Posted: Mon Dec 05, 2005 2:30 pm
by skf
Thanks for answer.
Could you give me advice how to do that?
Thanks


ScalixSupport wrote:Hi. It sounds like you've setup SA using the two IP address method wth sendmail listening on one IP address and Scalix smtpd listening on the other. I assume when you say "nobody can connect to scalix" you mean none of your user's that submit messages with SMTP can connect. If that's the case, it's because you have the user's connecting to sendmail rather than Scalix. Have them go to ther other IP address (the one with smtpd listening) and they should be fine.

Thanks,
Rachel